Laurel-electronics QLS Quad Output 4-20 mA Current Loop - Manual Manuel d'utilisateur télécharger pdf (Page 4)

- 4 -

6. JUMPER SETTINGS

The four outputs are always 4-20 mA process loops. The

signal input can be 4-20 mA, 1-5V, 0-5V or 0-10V, as set

by jumpers adjacent to the signal input connector on the

circuit board. The factory default input setting is 4-20

mA. To change jumpers, remove power, then open the

case by removing the screws at the four corners of the

case. Store the unused jumper, if any, on an unused pin.

Jumper Positions:

4-20 mA ............................a + c

1-5V ....................................... d

0-5V .................................. b + f

0-10V .............................. a + e

7. ELECTRICAL CONNECTIONS

1 2 3 4 5 6 7 8

Pas de commentaire

Laurel-electronics QLS Quad Output 4-20 mA Current Loop - Manual Manuel d'utilisateur Page 4